1. Home
  2. Version Compilation and Programming
  3. Step 3: Enter recovery/forced-download mode on HiKey960

Step 3: Enter recovery/forced-download mode on HiKey960

  • Remove power from the board
  • Change Jumper/DIP switch settings, to enter recovery/forced-download mode:
NameLink / SwitchState
Auto Power upLink 1-2 / Switch 1closed / ON
RecoveryLink 3-4 / Switch 2closed / ON
FastbootLink 5-6 / Switch 3open / OFF
  • Apply power to the board using 96Boards compliant power supply
  • Insert USB Type-C cable (OTG port) to the board, and connect the other end to your Linux PC
  • Check whether there is a device node “/dev/ttyUSBx”. If there is, it means your PC has detected the target board; If there is not, try to repeat previous steps.
Was this article helpful to you? Yes No

How can we help?